top of page

00-05 CHEVY MONTE CARLO

Here we will install the 00-05 Chevy Monte Carlo High Beam Kit in a 2000 Chevy Monte Carlo

Let’s open the hood and get started. On the left side, or Drivers
there are 2 head light retainer pins that need to be removed. Simply pull the
retainer pins up, and pull the head light out, and unhook the wiring harness socket.
Clean the wiring back and hold the plug-in hand like this with the clip facing you
as seen in this picture. The top wire will be
BLUE & the bottom wire will be BLUE.

00-05 Monte Carlo Pic 1.jpg

On the clip you will notice small letters showing what holes the wires are in.

00-05 Monte Carlo Pic 2.jpg

These will be the wires you will install the red T-Taps into.
PINK TO PINK
FUSE LINK TO ORANGE
BLUE TO BLUE

00-05 Monte Carlo Pic 3.jpg

Now install the conversion box to the ground stud on the core support
beside the head light mounting bracket. Leave it loose for now, just get it started.
It does not have to go up against it, just close enough the head light will still fit!

Were almost done! We now re-install the head light and make sure you
install both retainer clips. Tighten down the ground nut.

DO NOT OVER TIGHTEN!!

Your ride should look like this now with the HIGH BEAMS on....lighting up the road!

MC HB 2023.jpg

If you have any questions about your install, please contact us at:


419-947-6955

bottom of page